Filter
Top Products
Reelmaster 5010- H Hydraulic SystemPage 4 - 59
Removal (Fig. 52)
1. Thoroughly cleanhydraulic hoseends andfittings on
hydraulicreservoir topreventh ydraulic systemcontami-
nation.
2. Drain hydraulic oil from reservoir.
3. Disconnect hydraulic lines from fittings on the reser-
voir.Allowhydraulic linesto draininto asuitablecontain-
er. Plug or cap openings of reservoir and hydraulic lines
to prevent leakage or c ontamination.
4. Remove hydraulic reservoir using Figure 52 as a
guide.
5. Remove suction strainer (item 1)f rom reservoir.Dis-
card O- ring.
6. If hydraulic fitting (item 15) is to be removed from re-
servoir, mark fitting orientation to allow correct assem-
bly. Remove fitting from reservoir and discard O- ring.
Inspection (Fig. 52)
1. Clean hydraulic reservoir and suction strainer with
solvent.
2. Inspect hydraulic reservoir for leaks, cracks or other
damage.
Installation (Fig. 52)
1. If fitting (item 15) was removed from reservoir, lubri-
cate and place new O- ring onto fitting. Install fitting into
reservoiropening using marksmade duringthe removal
process to properly orientate fitting. Tighten fitting (see
Hydraulic Fitting Installation in the General Information
section of this chapter).
2. Lubricate new suction strainer O- ring and install
onto strainer. Thread suction strainer into hydraulic res-
ervoiruntil fingertight. Then,using awrench, turnstrain-
er into reservoir port 1- 1/2 to 2 full turns beyond finger
tight.
3. Position hydraulic reservoir to machine. Make sure
that recess bumper (item 3) on right side of frame is in-
serted into recess in reservoir.
4. Secure reservoir to frame with two (2) clamps (item
4), washer head screws (item 8) and flange nuts (item
9).
5. Remove plugs and caps placed in hoses and fittings
during the removal process.
6. Install and secure hydraulic lines to fittings on hy-
draulic reservoir(see Hydraulic Hoseand Tube Installa-
tion in the General Information section of this chapter).
7. Fill hydraulic reservoir with new hydraulic fluid.
8. Operate machine. Check hydraulic lines and fittings
forleaks.Tightenanyloose connections.Checkhydrau-
lic oil level in reservoir and adjust if necessary.
Hydraulic
System