Filter
Top Products
Reelmaster 5010- H
Cutting Units
Page 7 - 6
Spline Insert Tool
Toro Part Number: TOR4112 (8toothfor5inchreels)
TOR4074 (9toothfor7inchreels)
Usespline inserttool forrotatingcutting reelwhenmotor
is removed.Also use this tool forinstallation of threaded
inserts into cutting reel shaft.
Figure 9
Rear Roller Bearing and Seal Installation Tools
Toro Part Number: 115- 0803
This tool kit is used to assemble the cutting unit rollers.
Tools in this kit are also available individually as follows:
115- 0852 Inner Seal Tool
115- 0853 Bearing/Outer Seal Tool
107- 8133 Bearing Installation Washer
Figure 10
Inner Seal
Tool
Bearing/Outer Seal
Bearing Installation
Washer
Tool
Plastic Plug
Toro Part Number: 2410- 30 (for5inchreels)
94- 2703 (for7inchreels)
This cap is used for placement into the cutting u nit side
plate when thecutting reelmotor is removed. Itprevents
dirt and debris from entering the cutting reel bearing
area.
Figure 11