Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 86
CrossTrax
TM
AW D Manifold (Machines with Option al CrossTrax
TM
Kit)
1. CrossTrax AWD manifold
2. Hydraulic tube
3. Hydraulic tube
4. Hydraulic tube
5. O-ring
6. Hydraulic fitting (7 used)
7. O-ring
8. Dust cap (2 used)
9. Diagnostic fitting (2 used)
10. O-ring
11. Cap screw (3 used)
12. Lock washer (3 used)
13. Spacer (3 used)
14. Hydraulic hose (4 used)
15. Frame bracket
Figure 73
FRONT
RIGHT
4
3
1
2
9
10
11
8
5
6
7
12
13
14
15
Removal (Fig. 73)
1. Park themachine ona level surface, engage parking
brake, lower cutting units and stop engine. Remove key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
3. Locate CrossTrax
TM
AWD manifold that is attached
tobracketatrearofframe.
4. Label all hydraulic connections for assembly pur-
poses. Thoroughly clean hydraulic connections prior to
loosening h ydraulic lines.
CAUTION
Before opening hydraulic system, operateall hy-
draulic controls to relieve system pressure and
avoid injury from pressurized h ydraulic oil. See
Relieving Hydraulic System Pressure in the Gen-
eral Information section of this chapter.
5. Disconnect hydraulichoses andtubesfrom fittingsin
manifold. Allow lines to drain into a suitable container.
Remove and discard O- rings.