Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 98
Steering Cylinder
1. Steering cylinder
2. Retaining ring
3. Grease fitting
4. Hydraulic hose
5. O-ring
6. 90
o
hydraulic fitting
7. O-ring
8. Hydraulic hose
9. Grease fitting
10. Ball joint
11. Jam nut
12. Cotter pin
13. Slotted hex nut
14. Washer
15. Ball joint
Figure 81
FRONT
RIGHT
9
10
11
4
3
7
13
2
12
8
6
7
14
1
5
5
6
15
Removal (Fig. 81)
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
CAUTION
Before opening hydraulic system, operateall hy-
draulic controls to relieve system pressure and
avoid injury from pressurized h ydraulic oil. See
Relieving Hydraulic System Pressure in the Gen-
eral Information section of this chapter.