Filter
Top Products
Reelmaster 5010- HPage 5 - 6Electrical System
Special Tools
Order Special Tools from your Toro Distributor.
Digital Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage. Obtain this tool
locally.
NOTE: Toro recommends the use of a DIGITAL Volt-
Ohm- Amp multimeter when testing electrical circuits.
Thehighimpedance(internalresistance) ofa digitalme-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current could cause damage to circuits not designed to
carry it.
Figure 3
Battery Terminal Protector
Toro Part Number: 107-0392
Aerosol spray that should be used on battery terminals,
ring terminals and fork terminals to reduce corrosion
problems. Apply terminal protector to the connection af-
ter the battery cable, ring terminal or fork terminal has
been secured.
Figure 4
Dielectric Gel
Toro Part Number: 107-0342
Dielectricgelshouldbeusedtopreventcorrosionofun-
sealed connection terminals. To ensure complete coat-
ing of terminals, liberally apply gel to both component
and wire harness connector, plug connector to compo-
nent,unplug connector, reapplygel toboth surfacesand
reconnect harness connector to component. Connec-
tors should be thoroughly packed with gel for effective
results.
Do notuse dielectric gel on sealedconnection terminals
as the gel can unseat connector seals during assembly.
Figure 5