Filter
Top Products
Reelmaster 5010- H Page 6 - 5 Chassis
Removal (Fig. 3)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen, but do not remove, wheel lug nuts.
When changing tires, attachments or perform-
ing other service, use correct hoists, jacks and
jack stands. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
mentsthat mayinterfere withthe safeand prop-
er raising of the machine. Always chock or
block wheels. Use jack stands or other ap-
propriate load holding devices to support the
raised machine. If the machine is not properly
supported,themachine maymove orfall, which
may result in personal injury.
CAUTION
4. Using a jack, raise machine so wheel is of f ground
(see Jacking Instructions in Chapter 1 - Safety). Sup-
port machine with jack stands.
5. Remove wheel lug nuts andthen remove wheel from
machine.
Installation (Fig. 3)
1. Install wheel and secure with five (5) wheel lug nuts.
2. Lower machine to ground.
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury.
3. Torque wheel lug nuts evenly in a crossing pattern
from 70 to 90 ft-lb (95 to 122 N- m).
Chassis