Filter
Top Products
Reelmaster 5010- H GroomerPage 8 - 5
Troubleshooting
Groomer Reel Mechanical Problems
Problem Possible Causes Correction
No rotation of the groomer reel. The groomer drive belt needs to be
adjusted.
Failed groomer idler bearing(s) in
groomer side plate(s).
Broken or damaged idler spring.
The g roomer drive belt is worn, bro-
ken or damaged.
Grooming depth is too deep.
Groomer d rive shaft is loose in cut-
ting reel.
Groomer drive pulley square key is
damaged or missing.
Flange head screw that secures
groomer drive pulley is loose or
damaged.
Adjust groomer drive belt.
Replace faulty bearing(s).
Replace spring.
If the drive belt slips, it probably is
out of adjustment or worn.
Repair or replace drive belt if nec-
essary. A broken or worn belt could
be the result of improper belt rout-
ing or seized bearings in groomer
assembly.
Change grooming depth.
Correctly tighten groomer drive
shaft. Replace drive shaft if threads
are faulty.
Replace missing or damaged
square key.
Correctly tighten groomer drive pul-
leywithexistingflangeheadscrew.
Replace screw if threads are faulty.
The turf is damaged or has uneven
grooming.
The groomer reel blades are bent,
damaged or missing.
The groomer reel shaft is bent or
damaged.
Grooming depth is not equal on
both ends of groomer reel.
Repair or replace blades if neces-
sary.
Replace groomer reel shaft.
Adjust depth if necessary. Also,
check and adjust cutting unit set up
(level bedknife to reel, level rear
roller to reel, set height- of- cut,
etc.).
Groomer