Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 26
Traction Circuit Problems
Problem Possible Cause
Neutral is difficult to find or unit oper-
ates in one direction only
Traction control linkage is misadjusted, disconnected, binding or
damaged.
Piston (traction) pump check relief valve is not seating or is dam-
aged (NOTE: Piston (traction) pump check relief valves for forward
and reverse are identical and can be reversed for testing pur-
poses).
Piston (traction) pump is worn or damaged.
Traction response is sluggish Charge pressure is low.
Hydraulic oil is very cold.
Parking brake is dragging or binding.
Piston (traction) pump bypass valve is not seated.
Flushing valve in piston (traction) pump is not seating or is dam-
aged.
Piston (traction) pump charge relief valve is not seating or is dam-
aged.
Piston (traction) pump check relief valve is not seating or is dam-
aged (NOTE: Check relief valves for forward and reverse are iden-
tical and can be reversed f or testing purposes).
Piston (traction) pump is worn or damaged.
No traction in either direction Parking brake is dragging or binding.
Traction control linkage is misadjusted, disconnected, binding or
damaged.
Oil level in hydraulic reservoir is low (other hydraulic systems af-
fected as well).
Piston (traction) pump bypass valve is loosened.
Flushing valve in piston (traction) pump is not seating or is dam-
aged.
Piston (traction) pump check valve is not seating or is damaged.
Charge pressure is low.
Wheel motor(s) and/or piston (traction) pump are worn or damaged
(NOTE: If a traction circuit component has internal wear or dam-
age, it is possible t hat other traction components are also dam-
aged).
Single wheel motor turns while un-
loaded, but slows down or stops
when load is applied
Wheel motor is worn or damaged.
(NOTE: If a traction circuit component has internal wear or dam-
age, it is possible t hat other traction components are also dam-
aged)