Filter
Top Products
Reelmaster 5010- HPage 5 - 90Electrical System
Cutting Reel Motor Service
1. Torx head screw ( 12 used)
2. Motor cover
3. O-ring
4. Wave washer (2 used)
5. Bearing (2 used)
6. Rotor
7. Bearing (2 used)
8. O-ring (2 used)
9. Housing/controller/cable assembly
10. O-ring
11. Output gear
12. Gearbox cover
13. Shaft seal
14. O-ring
Figure 95
5
7
7
5
6
11
8
1
4
3
10
8
9
12
14
13
2
4
1
70 to 80 in-lb
(8 to 9 N-m)
70 to 80 in-lb
(8 to 9 N- m)
NOTE: Ifmotorhousing,controllerorcabledamageoc-
curs, cutting reel motor replacement is necessary.
These components are not available separately.
IMPORTANT: When working on the cutting reel mo-
tor, use a clean work space with a non- metal sur-
face. The reel motor rotor includes very powerful
magnetsthat cancausethe rotorto moveunexpect-
edlyif workingon ametal surface.Also, anymetallic
debris that gets attracted to the rotor can damage
the motor after assembly.
Disassembly (Fig. 95)
1. Remove six (6) torx head screws that secure gear-
box cover (item 12) to front of motor housing.
2. Carefully slide gearbox cover from front of motor.
3. Remove and discard O- rings (items 8 and 10) from
gearbox cover.
4. Slide output gear assembly (items 5, 11 and 7) from
motor housing. Remove wave washer (item 4).
5. Remove six (6) torx head screws t hat secure motor
cover (item 2) to rear of motor housing. Leave cover on
rotor shaft.
IMPORTANT: The rotor magnets are very powerful
andcan causethe rotorto shiftposition veryrapidly
duringremoval. Use cutting reelmotor rotortool set
(see Special Tools in this chapter) to remove rotor.
Becautious duringrotorremovalto preventcompo-
nent damage or personal injury.