Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 92
Lift Cylinder Service
1. Grease fitting
2. Shaft
3. Dust seal
4. Head
5. BS seal
6. Retaining ring
7. Back up washer
8. O-ring
9. Piston
10. Wear ring
11. BP seal
12. O-ring
13. Lock nut
14. Barrel
15. Grease fitting
Figure 76
2
3
4
5
6
9
8
7
1
10
11
14
12
13
2345
6
9
8710 11
1412
13
15
40 ft-lb
(54 N-m)
NOTE: The front, outside lift cylinders are longer with
more strokethan the other lift cylinderswhich are identi-
cal. Service procedures for all lift cylinders used on Re-
elmaster 5010- H machines are the same.
Disassembly (Fig. 76)
1. Remove oilfromliftcylinderinto adrainpan byslowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the clevis end of
the barrel ONLY.
2. Mount lift cylinder securely in a vise by clamping on
the clevis end of the barrel. Use of a vise with soft jaws
is recommended.