Filter
Top Products
Reelmaster 5010- H GroomerPage 8 - 15
4. Using wrench on shaft flats to prevent shaft from
turning, torque second lock nut from 375 to 425 in- lb
(43to48N-m). After torquing lock nut, spacers should
not be free torotate and groomerblades should becen-
teredonshaft.
5. If groomer reel is equipped with broomer kit,position
broomer brushes to reel blades and secure with straps.
Straps should be wrapped around the groomer assem-
bly as shown in Figure 17 and between blades 1- 2,
14- 15, 28- 29 and 41- 42. Pull straps tight and cut off
strap extension approximately 1/4” (6 mm) beyond re-
tainer.
6. Apply a film of grease onto excluder seal lips and
slide seals onto groomer shaft. Excluder seal ID should
belocatedongroomershaft surface that is recessed
slightly.
7. Install O- ring on non- drive end of groomer shaft.
8. Install groomer reel back on cutting unit (see Groom-
er Reel in this section).
9. Checkgroomer reelheightandmowerheight- of- cut
settings. Adjust as needed.
10.Lubricate groomer bearings.
11.Install cutting unit back on machine.
NOTE: After greasing groomer bearings, operate
groomer for thirty (30) seconds, stop machine and wipe
excess grease from groomer shaft and seals.
1. Groomer shaft 2. Broomer strap
Figure 17
1
2
2
2
2
Groomer