Filter
Top Products
Reelmaster 5010- HPage 6 - 26Chassis
Rear Lift Arms
1. Housing
2. #2 lift arm
3. #3 lift arm
4. Washer (2 used per chain hoop)
5. Washer (2 used)
6. Flange head screw (2 used)
7. Shoulder stud (6 used)
8. Grease fitting
9. Pivot shaft (2 used)
10. Washer head screw (1 used per shaft)
11. Pivot yoke (2 used)
12. Lynch pin (2 used)
13. Thrust washer (2 used per yoke)
14. RH torsion spring
15. LH torsion spring
16. Snapper pin (1 used per yoke)
17. Cap (1 used per yoke)
18. Chain hoop (2 used)
19. Lock nut (6 used)
20. Cap screw ( 2 used per chain hoop)
21. Flange nut (2 used per chain hoop)
22. Chain (2 used)
Figure 24
FRONT
RIGHT
2
3
8
10
11
13
1
7
12
16
17
18
19
20
4
21
22
14
15
5
13
6
5
9
8
8
Removal (Fig. 24)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove cutting unit from rear lift arm that is to be re-
moved.
3. Remove one retaining ring (item 3 in Fig. 25) and
thrust washer (item 4 in Fig. 25) from the cylinder pin
(item 5in Fig. 25) that secureslift cylinder tolift arm. Pull
cylinder pin from the lift cylinder and lift arm. Locate and
retrieve second thrust washer.
4. Pivot lift cylinder rod end away from lift arm.