Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 78
Rear Wheel Motors ( Machines with Optional CrossTrax
TM
Kit)
1. Lug nut (5 used per wheel)
2. Rear wheel assembly
3. Wheel hub assembly
4. Lock nut
5. Woodruff key
6. 45
o
hydraulic fitting (2 per motor)
7. O-ring
8. O-ring
9. Hydraulic hose (4 used)
10. Cap screw (4 per motor)
11. Lock washer (4 pe r motor)
12. LH rear wheel motor
13. RH rea r wheel motor
14. CrossTrax
TM
control manifold
Figure 67
2
3
6
8
9
10
11
13
1
5
7
12
14
4
6
8
7
70 to 90 ft-lb
(95 to 122 N-m)
(367 to 447 N-m)
270 to 330 ft-lb
FRONT
RIGHT
70 to 80 ft- lb
(95 to 108 N-m)
Removal (Fig. 67)
1. Park the machine on a level surface, lower the cut-
ting units and stop the engine. Remove the key from the
ignition switch.
2. Chock rear wheels to prevent machine from moving
or shifting.
3. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
4. Loosen, but do not remove, lock nut (item 4) from
rear wheel motor shaft.
5. Remove rear wheel from machine (see Wheels in
the Service and Repairs section of Chapter 6 - Chas-
sis).