Filter
Top Products
Reelmaster 5010- H
Cutting Units
Page 7 - 2
Specifications
Figure 1
Frame Construction: Precision machined die cast alu-
minum cross member with two (2) bolt- on aluminum
side plates.
Reel Construction: Reels are 22 inches (55.9 cm.) in
length and are available in 5 inch (12.7 cm) and 7 inch
(17.8 cm) diameters. High strength, low alloy steel
blades are thru hardened and impact resistant. 5 inch
and7inchreelsareavailableinboth8and11bladecon-
figurations.
Reel Bearings: Two (2) sealed, stainless steel ball
bearings support the reel shaft with inboard spacer for
protection.
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with LH and RH drive inserts
threaded into both ends. The drive inserts for 5 inch re-
els have an internal eight (8) tooth spline. The drive in-
serts for 7 inch reels have an internal nine (9) tooth
spline.
Height-of- Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending onturf conditions,type of bedknife,
roller type and installed attachments.
Bedknife: Replaceable, toolsteel EdgeMax
TM
bedknife
is fastened to a machined cast iron bedbar with eight (8)
screws. Optional bedknives are available.
Bedknife Adjustment: Dual screw assemblies allow
for precise bedknife adjustment. Adjustment detents
correspond to bedknife movement for each indexed po-
sition as follows:
0.0007 inch (0.018 mm) for 5 inch reel
0.0009 inch (0.022 mm) for 7 inch reel
Front and Rear Rollers: Greaseable through- shaft
front and rear rollers are used with these cutting units.
All rollers use the same heavy duty, stainless steel ball
bearings and seal package.
Cutting Unit Weight (without end weight):
8 Blade, 5 inch reel 90 lb. (41 kg)
11 Blade, 5 inch reel 93 lb. (42 kg)
8 Blade, 7 inch reel 118lb.(54kg)
11 Blade, 7 inch reel 121lb.(55kg)
Options: Refer to Cutting Unit Operator’s Manual for
available options for your Reelmaster cutting unit.