Filter
Top Products
Reelmaster 5010- HHydraulic System Page 4 - 80
Rear Wheel Motor Service (Machines with Optional CrossTrax
TM
Kit)
1. Cap screw (7 used)
2. End cover
3. Body seal (5 used)
4. Commutator ring
5. Commutator
6. Commutator ring
7. Manifold
8. Stator
9. V ane (7 used)
10. Rotor
11. Wear plate
12. Drive link
13. Thrust be aring
14. Coupling shaft
15. Thrust be aring
16. Thrust washer
17. Inner bearing
18. Shaft seal
19. Back-up washer
20. Back-up ring
21. Housing
22. Outer bearing
23. Dirt and water seal
Figure 68
(61 to 75 N-m)
45 to 55 ft- lb
4
3
1
2
9
10
11
8
5
6
7
12
3
3
3
3
13
14
15
16
17
18
19
20
21
22
23
NOTE: The rear wheel motors used on machines with
the optional CrossTrax
TM
Kit are Parker Torqmotor
TM
motors of the same basic design with minordifferences.
The right side motor has a reverse timed manifold to al-
low correct rotation direction for forward and reverse.
The left side wheel motor is identified with a yellow dot
on the motor housing near the B port.
NOTE: For Parker wheel motor repair procedures, see
the Parker Torqmotor
TM
Service Procedure (TC, TB,
TE, TJ, TF, TG, TH and TL Series) at the end of this
chapter.
IMPORTANT: Ifawheel motorfailureoccurred,refer
to Traction Circuit Component Failure in the Gener-
al Information section for information regarding the
importance of removing contamination from the
traction circuit.