Filter
Top Products
Reelmaster 5010- H
Cutting Units
Page 7 - 16
Bedbar Assembly
1. Bedbar assembly
2. Flange bushing (2 used)
3. Plastic washer (4 used)
4. Metal washer (2 used)
5. Bedbar pivot bolt (2 used)
6. Lock nut (2 used)
7. Lock nut (2 used)
8. Compression spring (2 used)
9. Washer (2 used)
10. Bedbar adjuster screw (2 used)
11. Cutting unit frame
12. RH side plate
13. Cutting reel assembly
14. LH side plate
Figure 21
7” CUTTING REEL SHOWN
FRONT
RIGHT
Antiseize
Lubricant
2
3
6
8
9
10
11
13
1
5
7
12
14
4
3
Bedbar Removal (Fig. 21)
1. Position machine on a clean andlevel surface, lower
cutting units, stop engine,engage parking brake and re-
move key from the ignition switch.
2. To preventunexpected reel motor operation,discon-
nect motors from the electrical power supply by unplug-
ging the 48 VDC battery disconnect (see 48 VDC
BatteryDisconnect int he GeneralInformationsectionof
this chapter).
3. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools in this chapter).
4. Loosen thelock nuts (item7) onthe endof eachbed-
bar adjuster assembly until washer (item 9) is loose.
5. Loosen the lock nuts (item 6) on each bedbar pivot
bolt (item 5).