Toro 5010-H Lawn Mower User Manual


 
Reelmaster 5010- HHydraulic System Page 4 - 76
Front Wheel Motor Service
1. Cap screw (7 used)
2. End cap
3. O-ring (3 used)
4. Geroler assembly
5. Valve plate
6. Thrust bearing
7. Bearing
8. V alve
9. Dowel pin (4 used)
10. Balancing ring
11. Valve spring
12. Back-up ring
13. O-ring
14. Drive
15. Output shaft
16. Bearing race (2 used)
17. Thrust bearing
18. Shaft seal
19. Housing
20. Bearing
21. Grease seal
Figure 66
(61to75N-m)
45 to 55 ft- lb
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
21
3
3
12
16
NOTE: The front wheel motors are Eaton Delta motors
of the same basic design with minor differences. The
right side motor has a reverse timed manifold to allow
correct rotation direction for forward and reverse. The
left side wheel motor can be identified by the machined
groove on the end of the output shaft.
NOTE: For front wheel motor repair procedures, see
the Eaton Delta Motors Parts and Repair Manual at the
end of this chapter.
IMPORTANT: Ifawheel motorfailureoccurred,refer
to Traction Circuit Component Failure in the Gener-
al Information section for information regarding the
importance of removing contamination from the
traction circuit.