Filter
Top Products
Reelmaster 5010- H Hydraulic SystemPage 4 - 87
6. Put caps or plugs on disconnected lines and fittings
to prevent contamination.
7. Support manifold to prevent it from falling. Remove
three (3)cap screws and lockwashers that secureman-
ifold to machine frame. Locate and retrieve three (3)
spacers from between frame bracket and manifold.
8. Remove AWD manifold from machine.
9. If necessary, removehydraulicfittingsfrom manifold.
Discard any removed O- rings.
Installation (Fig. 73)
1. If fittings were removed from AWD manifold, lubri-
cate and placenew O- rings tofittings. Installfittings into
manifold (see Hydraulic Fitting Installation in theGener-
al Information section of this chapter).
2. Position manifold and three (3) spacers to frame
bracket. Install three (3) lock washers and cap screws
but do not fully tighten.
3. Remove caps and plugs from disconnected hy-
draulic lines and fittings.
4. Lubricate and install new O- ring(s) on manifold fit-
tings. Connect hydraulic lines to hydraulic manifold fit-
tings. Properly tighten all connections (see Hydraulic
Hose and Tube Installation in the General Information
section of this chapter).
5. Secure AWD manifold to frame by tightening three
(3) cap screws.
6. Check oil level in hydraulic reservoir and add correct
oil if necessary.
7. Follow hydraulic system start- up procedures (see
Hydraulic System Start- up in this section).
Hydraulic
System