Filter
Top Products
Reelmaster 5010- H Page 5 - 75 Electrical System
8. Use a multimeter to check resistance o f the fuel
sender across the two (2) sender terminals (Fig. 80).
A. Resistance with the float in the full position (com-
pletely up) should be from 5 to 8 ohms.
B. Resistance with the float in t he empty position
(completely down) should be from 89 to 95 ohms.
9. Replace fuel sender if testing determines that it is
faulty.
10.After testing, install sender into fuel tank and secure
with gasket and fuel sender ca p. Make sure that fuel fit-
tings on sender are orientated at 90
o
from right side of
tank as shown in Figure 79. Also, to prevent damage to
fuelsender duringassembly, make surethat fuelsender
does not turn as sender cap is tightened.
11.Install fuel hoses to fittings on sender and secure
with hose clamps. Connect fuel sender connector to
wire harness.
12.Secure sender cover to fuel tank with removed
screws.
Figure 80
1. Sender full position 2. Sender empty position
1
2
90
o
Electrical
System