Filter
Top Products
Reelmaster 5010- HPage 6 - 20Chassis
Operator Seat
1. Operator seat
2. Seat base
3. Seat adjuster w/latch
4. Flat washer (4 used)
5. Seat switch harness
6. Seat switch
7. Washer head screw (2 used)
8. Armrest bracket
9. Spacer
10. Armrest
11. Cap screw
12. Flange nut
13. Flat washer (4 used)
14. Flange head screw (3 used)
15. Socket head screw (4 used)
16. Seat adjuster
17. Flat washer
18. Seat bracket (2 used)
19. Cap screw (4 used)
20. Housing cap
21. R-clamp (2 used)
22. Manual housing
23. Seat belt buckle
24. Flange n ut (4 used)
25. Seat suspension
26. Flange head screw (4 used)
27. Cap screw ( 2 used)
28. Lock washer (2 used)
29. Seat belt
Figure 15
15
4
16
1
2
7
6
12
10
11
14
9
17
8
3
5
13
20
24
25
22
23
19
18
24
FRONT
RIGHT
21
26
27
28
29
27
28
13
IMPORTANT: The operator seat, seat base and con -
trol arm assembly are attached to the machine with
the same f asteners. Make sure to support the seat
base and control arm to prevent them from shifting
when removing the seat. Damage to control arm
electrical components and control arm wiring har-
ness can occur if the seat base and control arm are
not properly supported during seat removal.