Filter
Top Products
Reelmaster 5010- H
Cutting Units
Page 7 - 5
Bedknife Screw Tool
Toro Part Number: TOR510880
This screwdriver- type bit is madeto fit Toro bedknife at-
tachingscrews.Usethisbitwithatorquewrenchtose-
cure the bedknife to the bedbar.
IMPORTANT: To prevent damage to the bedbar, DO
NOT use an air or manual impact wrench with this
tool.
Figure 6
Handle Assembly
Toro Part Number: 29-9100
For applying lapping compound to cutting units while
keeping hands a safe distance from the rotating reel.
Components forthe handle assembly areavailable indi-
vidually as follows:
Brush 36- 4310
Handle 29- 9080
Handle cap 2410- 18
Figure 7
Cutting Unit Kickstand
Toro Part Number: 119-8010-03
The cutting unit kickstand is used to prop up the rear of
the cutting unit during service. Use of this tool stabilizes
the cutting unit and prevents the bedbar adjusting
screws from resting on the work surface.
Figure 8
Cutting
Units