Filter
Top Products
Reelmaster 5010- HPage 5 - 36Electrical System
Starting Problems (Continued)
Problem Possible Causes
Nothing happens when start attempt is made.
InfoCenter Display operates with the ignition switch in
RUN.
NOTE: Ifmachine controlsare notin the correctposition
to start the engine (e.g. the traction pedal is pressed), an
advisory message may be displayed on the InfoCenter
Display.
Traction pedal is not in neutral position.
Operator seat is unoccupied OR the parking brake is
not applied.
Cutting units are engaged (reel engage/disengage
switch is ON).
Thejoystickisnotinthe center position.
Traction neutral switch is out of adjustment.
Traction neutral switch or circuit wiring is faulty.
Seat switch or circuit wiring is faulty.
Parking brake switch or circuit wiring is faulty.
Joystick switch (raise or lower position) is faulty.
Ignition switch or circuit wiring is faulty.
Start relay or circuit wiring is faulty.
Main power relay or circuit wiring is faulty (headlights
and powerpoint inoperative as well).
TEC controller fuses are faulty.
Fusible link at battery is open.
Wiring to start circuit components is loose, corroded or
damaged (see electrical drawings in Chapter 9 -
Foldout Drawings).
Temperature sender or circuit wiring is faulty.
Starter solenoid or starter motor is faulty.
TEC controller is faulty.