Filter
Top Products
Reelmaster 5010- HGroomer Page 8 - 14
Groomer Reel Service
Figure 14
1. Groomer shaft
2. Lock nut (2 used)
3. Spacer (thick) (41 used)
4. Spacer (thin) (2 used)
5. Groomer blade (40 used)
6. Broomer brush (5 used)
7. Broomer strap (4 used)
4
3
1
2
5
7
6
Inspect groomer reel blades frequently for damage and
wear.Straighten bentbladeswitha pliers.Eitherreplace
worn blades or reverse the blades to put the sharpest
blade edge forward (Fig. 15). Blades that are rounded
to the midpoint of the blade tip must be reversed or re-
placed f o r best groomer performance.
Disassembly (Fig. 14)
1. Remove groomer r eel from cutting unit (see Groom-
er Reel in this section).
2. Remove excluder seals from groomer reel.
3. If groomer reel is equipped with broomer kit, remove
straps and broomer brushes from reel.
4. Remove lock nut from either end of the shaft.
5. Remove spacers and blades from groomer shaft. If
needed, remove second lock nut from shaft.
Assembly (Fig. 14)
1. Install lock nut on drive end of groomer shaft. Place
thick spacer, thin spacer and then first blade on shaft.
2. Alternately install thick spacers and blades making
sure that all blades are separated by a spacer.
3. When all blades have been installed, place thin
spacer and f inal thick spacer on shaft and then thread
second lock nut onto the shaft. Center blades on shaft
with lock nuts.
1. Groomer blade
2. Sharp edge
3. Dull (rounded) edge
Figure 15
ROTATION
GROOMER
3
2
1
1. Groomer reel shaft
2. Groomer blade (40 used)
3. Thick spacer (41 used)
4. Thin spacer (2 used)
5. Lock nut (2 used)
6. Excluder seal
7. O-ring groove
Figure 16
CENTERED ON SHAFT
1234556 6
7