Support User Manuals

Tektronix MSO4000 Landscape Lighting User Manual

Open as PDF

of 585

Command Groups

Table 2-32: Vertical Commands (cont.)

Command Description

REF<x>:LABel

Sets or returns the speciﬁed reference

waveform label

Sets or returns the vertical position for

reference channel <x>

REF<x>:TIMe? Returns the time that a reference waveform

was stored

REF<x>:VERTical:POSition Sets or returns the vertical position of the

speciﬁed reference waveform

REF<x>:VERTical:SCAle Sets or returns the reference w aveform

vertical scale in vertical units/div

SELect Returns information on which waveforms are

on or off and which waveform is selected.

SELect:BUS<x> Turnsonoroffthespeciﬁed bus waveform

or returns whether the speciﬁed bus channel

is on or off

SELect:CH<x> Turns on or off the speciﬁed waveform or

returns whether the speciﬁed channel is on

or off

SELect:CONTROl Sets or returns the waveform that is selected

as the implied recipient of channel-related

commands

SELect:D<x> Turns on the display of digital channel <x>

and resets the acquisition

SELect:MATH[1] Turns on or off the math waveform or returns

whether the math waveform is on or off

SELect:REF<x> Turns on o r off the speciﬁed reference

waveform or returns whether the speciﬁed

reference waveform is on or off

Waveform Transfer Command Group

Use the commands in the Waveform Tra nsfer Command Group to transfer

waveform data points to and from the oscilloscope. Waveform data points are a

collection of values that deﬁne a waveform. One data v alue usually represents

one data point in the waveform record. When working with envelope waveforms,

each data value is either the minimum or maximum of a min/max pair.

Before you transfer waveform data, you must specify the data format, record

length, and waveform source or destination.

MSO4000 and DPO4000 Series Programmer Manual 2-61

previous next