Filter
Top Products
Commands Listed in Alphabetical Order
Group
Bus
Syntax
BUS:B<x>:PARallel:WIDth <NR1>
BUS:B<x>:PARallel:WIDth?
Arguments
<NR1> is the number of bits.
BUS:B<x>:POSition
Sets or returns the position o f the bus <x> waveform on the display, where x is
the bus number 1 through 4.
Conditions
This command requires a DPO4AUTO, DPO4EMBD, or DPO4COMP application
module.
Group
Bus
Syntax
BUS:B<x>:POSition <NR3>
BUS:B<x>:POSition?
Arguments
<NR3> specifies the position.
BUS:B<x>:RS232C:BITRate
Sets or returns the RS-232 bit rate for bus <x>, where x is the bus number.
Conditions
This command requires a DPO4COMP application module.
Group
Bus
Syntax
BUS:B<x>:RS232C:BITRate <NR1>
BUS:B<x>:RS232C:BITRate?
Arguments
<NR1> is the bit rate in bits-per-second. You can enter any positive integer, and
the instrument will coerce the value to the c losest supported bit rate.
2-102 MSO4000 and DPO4000 Series Programmer Manual