Filter
Top Products
Commands Listed in Alphabetical Order
Arguments
RXSTArt specifi
es a search based on the RX Start Bit.
RXDATA spec ifies a search based on RX Data.
RXENDPacket specifies a search based on the RX End of Packet condition.
TXSTArt specifies a search base on the TX Start Bit.
TXDATA spec ifies a search based on TX Data.
TXENDPacket specifies a search based on the TX End of Packet condition.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS232C:RX:DATa:SIZe
Sets or returns the length of the data string for an RS-232 trigger search if the
trigger condition is RX.
SEARCH<x> is the search number and B<x> is the bus
number.
Conditions
This command requires a DPO4COMP application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:RS232 C:RX:DATa:SIZe
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:RS232 C:RX:DATa:SIZe?
Arguments
<NR1> is the length o f the data string in Bytes.
SEARCH:SEARCH<x>:TRIGger:A:BUS:B<x>:RS232C:RX:DATa:VALue
Sets or returns the binary data string for an RS-232 trigger search if the condition
involves RX.
SEARCH<x> is the search number and B<x> is the bus number.
Conditions
This command requires a DPO4COMP application module.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:RS232 C:RX:DATa:VALue
SEARCH:SEARCH<x>:TRIGger: A:BUS:B<x>:RS232 C:RX:DATa:VALue?
2-358 MSO4000 and DPO4000 Series Programmer Manual