Filter
Top Products
Commands Listed in Alphabetical Order
the standard. I
EC Class C (Table 2) and MIL standards specify the limit as a
percentage of the fundamental.
Conditions
This command requires a DPO4PWR application m odule.
Group
Power
Syntax
POWer:HARMonics:RESults:H AR<1-400>:LIMit?
Examples
POWER:HARMONICS:RESULTS:H AR3:LIMIT? might return
:POWER:HARMONICS:RESULTS: HAR3:LIMIT 2.30 indicating that
the harmonic magnitude limit for IEC standard for the 3rd harmonic is set to
2.30 A.
POWer:HARMonics:RESults:HAR<1-400>:PHASe? (Query Only)
Returns the phase of the harmonic in degrees. The phase is measured relative
to the zero-crossing of the reference waveform. When there is no reference
waveform, the phase is relative to the fundamental component.
Conditions
This command requires a DPO4PWR application m odule.
Group
Power
Syntax
POWer:HARMonics:RESults:H AR<1-400>:PHASe?
Examples
POWER:HARMONICS:RESULTS:H AR400:PHASE? might return
:POWER:HARMONICS:RESULTS: HAR400:PHASE 0 indicating that the h armonic
phaseissetto0indegrees.
POWer:HARMonics:RESults:HAR<1-400>:RMS:ABSolute? (Query Only)
Returns the RMS magnitude of the harmonic in absolute units.
Conditions
This command requires a DPO4PWR application m odule.
Group
Power
2-260 MSO4000 and DPO4000 Series Programmer Manual