Filter
Top Products
Command Groups
Table 2-25: Measurement Commands (cont.)
Command
Description
MEASUrement:MEAS<x>:SOURCE2 Sets or returns the channel to which
measurements are sent
MEASUrement:MEAS<x>:STATE Sets or returns whether the specified
measurement slot is computed and
displayed
MEASUrement:MEAS<x>:STDdev? Returns the standard deviation of values
accumulated since the last statistical reset
MEASUrement:MEAS<x>:TYPe Sets or returns the measurement<x> type
MEASUrement:MEAS<x>:UNIts?
Returns measurement<x> units
MEASUrement:MEAS<x>:VALue? Returns the value of measurement<x>
MEASUrement:METHod Sets or returns the method used for
calculating reference levels
MEASUrement:REFLevel? Returns the current reference level
parameters
MEASUrement:REFLevel:ABSolute:HIGH Sets or returns the top reference level for
rise time
MEASUrement:REFLevel:ABSolute:LOW Sets or returns the low reference level for
rise time
MEASUrement:REFLevel:ABSolute:MID Sets or returns the mid reference level for
measurements
MEASUrement:REFLevel:ABSolute:MID<x> Sets or returns the mid reference level in
absolute units (e.g. volts)
MEASUrement:REFLevel:ABSolute:MID2 Sets or returns the mid reference level for
delay "to" measurements
MEASUrement:REFLevel:METHod Sets or returns the method for assigning high
and low reference levels
MEASUrement:REFLevel:PERCent:HIGH Sets or returns the top reference percent
level for rise time
MEASUrement:REFLevel:PERCent:LOW Sets or returns the low reference percent
level for rise time
MEASUrement:REFLevel:PERCent:MID Sets or returns the mid reference percent
level for waveform measurements
MEASUrement:REFLevel:PERCent:MID2 Sets or returns the mid reference percent
level for second waveform measurements
MEASUrement:IMMed:SO Urce<x> Sets or returns the source for the current
single channel measurement
MEASUrement:MEAS<x>:SOUrce<x> Sets or returns the source for the specified
measurement.
MEASUrement:REFLevel:ABSolute:MID<x> Sets or returns the mid reference level for
the specified channel in absolute volts
MEASUrement:REFLevel:PERCent:MID<x> Sets or returns the m id reference level for
the specified channel in percent
MSO4000 and DPO4000 Series Programmer Manual 2-29