Filter
Top Products
Commands Listed in Alphabetical Order
Examples
POWER:RIPPLE:
RESULTS:STDDEV?
might return
:POWER:RIPPLE:RESULTS:STDD EV 0.14 indicating that the standard
deviation of the peak-to-peak amplitude is set to 0.14.
POWer:RIPPl
e:SOUrce
Sets or returns the source waveform for ripple tests. The voltage source waveform
is specified using the POWer:VOLTAGESOurce command and the current
waveform i
sspecified using the POWer:CURRENTSOurce command.
Conditions
This command requires a DPO4PWR application m odule.
Group
Power
Syntax
POWer:RIPPle:SOUrce {VOLTage|CURRent}
Arguments
VOLTage specifies voltage source waveform for ripple tests.
CURRent specifies current source waveform for ripple tests.
Examples
POWER:RIPPLE:SOURCE CURRent sets the ripple source to Current.
POWER:RIPPLE:SOURCE? might return :POWER:RIPPLE:SOURCE VOLT
indicating that the ripple source is set to Voltage.
POWer:SOA:LINear:XMAX
Sets or returns the user XMAX value for use in linear SOA calculations.
Conditions
This command requires a DPO4PWR application m odule.
Group
Power
Syntax
POWer:SOA:LINear:XMAX <NR3>
POWer:SOA:LINear:XMAX?
Arguments
<NR3> is the XMAX value used for linear SOA calculations.
MSO4000 and DPO4000 Series Programmer Manual 2-287