Filter
Top Products
Commands Listed in Alphabetical Order
Group
Bus
Syntax
BUS:B<x>:CAN:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8 |D9|D10|D11|D12 |D13|D14|D15}
BUS:B<x>:CAN:SOUrce?
Arguments
CH1–CH4 is the analog channel to use as the data source.
D0–D15 is the digital channel to use as the data source.
BUS:B<x>:DISplay:FORMAt
Sets or returns the display format for the numerical information in the bus
waveform <x>, where x is the bus number.
Conditions
This command requires a DPO4AUTO, DPO4EMBD, or DPO4COMP application
module.
Group
Bus
Syntax
BUS:B<x>:DISplay:FORMAt {BINary|HEXade cimal|ASCII|MIXe d}
BUS:B<x>:DISplay:FORMAt?
Related Commands
BUS:B<x>:TYPE
Arguments
BINary specifies a binary d
ata display.
HEXadecimal specifies a hexadecimal data display.
ASCII specifies an ASCII format for RS-232 only.
MIXed specifies a mixed format for LIN and FlexRay only.
BUS:B<x>:DISplay:TYPe
Sets or returns the display type for bus <x>, where x is the bus number. You
can s et up the bus to display the protocol information, the logic waveforms that
comprise the bus, or both.
Conditions
This command requires a DPO4AUTO, DPO4EMBD, or DPO4COMP application
module.
MSO4000 and DPO4000 Series Programmer Manual 2-93