Filter
Top Products
Commands Listed in Alphabetical Order
SEARCH:SEARC
H<x>:TRIGger:A:UPPerthreshold:REF<x>
Sets or returns the reference waveform upper threshold to determine where to
place a mark. This setting is applied to all reference waveform searches that uses
an upper thre
shold.
SEARCH<x> is the search number and REF<x> is the reference
channel number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :UPPerthreshold :REF<x> {TTL}
SEARCH:SEARCH<x>:TRIGger:A :UPPerthreshold :REF<x>?
Arguments
TTL specifies a preset TTL high level of 1.4 V.
SELect
Sets or returns the selected waveform display (controlled by the front-panel)
on or off.
Group
Vertical
Syntax
SELect {ON|OFF}
Arguments
ON turns the selected waveform display on.
OFF turns the selected waveform display off.
Examples
SELECT might return the following
:SELECT:BUS1 0;BUS2 0;CH1 1;CH2 0;CH3 0;CH4 0;MAT H 0;REF1
0;REF2 0;REF3 0;REF 4 0;CONTROL CH1
SELect:BUS<x>
This command turns on and off the display of the waveform for <x>, where x i
s
the bus number. The query returns whether the channel is on or off but does not
indicate whether it is the selected waveform.
Group
Vertical
MSO4000 and DPO4000 Series Programmer Manual 2-383