Filter
Top Products
Commands Listed in Alphabetical Order
Group
Display
Syntax
DISplay:INTENSITy:GRAticul e <NR1>
DISplay:INTENSITy:GRAticul e?
Arguments
<NR1> is the graticule intensity and ranges from 0 to 100 percent.
Examples
DISPLAY:INTENSITY:GRATICUL E? might return
DISPLAY:INTEnsITY:GRATICUL E 30
DISplay:INTENSITy:WAVEform
Sets and returns the display waveform intensity settings.
Group
Display
Syntax
DISplay:INTENSITy:WAVEform <NR1>
DISplay:INTENSITy:WAVEform ?
Arguments
<NR1> is the waveform intensity and ranges from 1 to 100 percent.
Examples
DISPLAY:INTENSITY:WAVEFORM ? might return
DISPLAY:INTEnsITY:WAVEFORM 60
as the intensity of the waveforms.
DISplay:PERSistence
Sets or returns the display persistence. This affects the display only.
NOTE. When Persistence is set to Infinite, it does not mean that the brightness
of any pixel should never decrease. The brightness o f a pixel is proportionally
dependent on the ratio between its intensity (which does NOT decrease at Infinite
Persistence) and the maximum value of intensity of any pixel on the screen. If a
particular pixel get hit less often than others, its brightness will decrease over
time. It will become less bright relative to the pixels that get hit often.
Group
Display
MSO4000 and DPO4000 Series Programmer Manual 2-161