Filter
Top Products
Commands Listed in Alphabetical Order
HSmode spec ifie
s a high-speed mode address.
EEPROM specifies an EEPROM address.
USER specifies a user address.
TRIGger:A:BUS:B<x>:I2C:ADDRess:VALue
Sets or retu
rns the binary address string used for the I
2
C trigger if the trigger
condition is ADDRESS or ADDRANDDATA. Applies to bus <x>, where x is the
bus number.
Conditions
This command requires a DPO4EMBD application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:I2C:AD DRess:VALue <QString>
TRIGger:A:BUS:B<x>:I2C:AD DRess:VALue?
Arguments
<QString> is up to 7 or 10-bits depending o n the address mode that specifies the
address.Theonlyallowedcharactersinthe
QString are0,1,andX.
Examples
TRIGGER:A:BUS:B1:I2C:ADDR ESS:VALUE 1011 sets the I
2
C address value
to XXX1011.
TRIGger:A:BUS:B<x>:I2C:CONDition
Sets or returns the trigger condition for an I
2
C trigger. Applies to bus <x>, where
x is the bus number.
Conditions
This command requires a DPO4EMBD application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:I2C:CO NDition
{STARt|STOP|REPEATstart|A CKMISS|ADDRess|D ATA|ADDRANDDATA}
TRIGger:A:BUS:B<x>:I2C:CO NDition?
2-414 MSO4000 and DPO4000 Series Programmer Manual