Filter
Top Products
Reelmaster 7000 Hydraulic SystemPage 4 -- 5
Relieving Hydraulic System Pressure
Before disconnecting or performingany work onthe hy-
draulic system, all pressure in the hydraulic system
mustberelieved.Parkmachineon alevelsurface,lower
cutting units fully, stop engine and apply parking brake.
To relieve hydraulic pressure in traction circuit, move
traction pedal to both forwardand reverse directions. To
relieve hydraulic pressure in steering circuit, rotate
steering wheel in both directions.
Systempressure inmow circuit isrelieved whenthe cut-
ting units aredisengaged (PTO switch in OFF position).
To relieve hydraulic pressure inlift circuit, fully lower the
cutting units to the ground. Turn ignition switch to OFF.
Traction Circuit Component Failure
The traction c ircuit on Reelmaster 7000 machines is a
closed loop system that includes the piston (traction)
pump, two (2) front wheel motors and the rear axle mo-
tor. If a component in the traction circuit should fail, de-
bris and contamination from the failed component will
circulate throughoutthe tractioncircuit. This contamina-
tion can damage other components in the circuit so it
must be removed to prevent additional component fail-
ure.
The recommended method of removing traction circuit
contamination would be to temporarily install the Toro
high flow hydraulic filter (see Special Tools in this chap-
ter) into the circuit. This filter should be used when con-
necting hydraulic test gauges in order to test traction
circuitcomponents orafter replacinga failedtraction cir-
cuit component (e.g. traction (piston) pump or wheel
motor). The filter will ensure that contaminates are re-
movedfromtheclosed loopandthus,donotcauseaddi-
tional component damage.
Once the Toro high flow hydraulic filter kit has been
placed in thecircuit, raise and support the machinewith
all drive wheels off the ground. Then, operate the trac-
tion circuit to allow oil flow throughout thecircuit. Thefil-
ter will remove contamination from the traction circuit
during operation. Because the Toro high flowfilter is bi--
directional, the traction circuit can be operated in both
the forward and reverse direction. The filter should be
removed from the machine after contamination has
been removed from the traction circuit. See Filtering
Closed--LoopTractionCircuitintheServiceandRepairs
section of this chapter for additional information on us-
ing the Toro high flow hydraulic filter.
Thealternative tousing theTorohigh flowhydraulic filter
kit after a traction circuit component failure would be to
disassemble, drain and thoroughly clean all compo-
nents, tubes and hoses in the traction circuit. If any de-
bris remains in the traction circuit and the machine is
operated,thedebris cancauseadditionalcircuitc ompo-
nent failure.
NOTE: If traction circuit contamination exists, the trac-
tion pump case drain could allow contaminates to enter
other hydraulic circuits on the machine.
Hydraulic
System