Filter
Top Products
Reelmaster 7000Hydraulic System Page 4 -- 102
Steering Control Valve
1. Steering wheel cover
2. Lock nut
3. Steering wheel
4. Flat washer
5. O--ring
6. Flange head screw (4 used)
7. Steering column
8. Steering control valve
9. Socket head screw (4 used)
10. Flange nut (4 used)
11. Tinnerman nut (4 used)
12. Column brace
13. Socket head screw (4 used)
14. O--ring
15. Straight fitting (5 used)
Figure 76
FRONT
RIGHT
2
3
5
4
7
8
9
10
11
6
13
12
1
6
6
20 to 26 ft--lb
(28to35N--m)
Antiseize
Lubricant
7to10ft--lb
(10to13N--m)
14
15
Antiseize
Lubricant
Removal (Fig. 76)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove fasteners that secure shroud to front of ma-
chine (Fig. 77). Remove shroud from machine to allow
access to steering control valve.
3. Remove four (4)flange head screws that securecol-
umn brace (item 12) to frame platform. Remove brace
frommachineto allowaccessto steeringcolumnfasten-
ers.
4. Slide rubber bellows up from bottom of steering col-
umn. Support steering column to prevent it from falling.
5. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
6. Thoroughly clean hydraulic connections prior to
loosening hydraulic lines.
7. Label all hydraulic connections for assembly pur-
poses. Note port designations on steering control valve
(Fig. 78).