Filter
Top Products
Reelmaster 7000 Page 5 -- 15 Electrical System
Adjustments
Mow/Transport Sensor
The mow/transport sensor is a normally open proximity
sensorthat closeswhen themowspeed limiteris placed
inthetransport position.Thesensor mountstoa bracket
on the footrest platform (Fig. 12). The sensing plate for
themow/transport sensorisa tabonthe mowspeedlim-
iter.
Adjustment
1. The gap between the mow/transport sensor and the
mow speed limiter should be from 0.040” to 0.100” (1.1
to 2.5 mm).
2. Ifgapisincorrect,loosenjamnutsthatsecuresensor
to footrest platform. Position switch with jam nuts to al-
low correct gap between sensor and mow speed limiter.
Tightenjam nuts to secureadjustment. Jam nutsshould
be torqued from 162 to 198 in--lb (18.4 to 22.4 N--m).
After jam nuts are tightened, make sure that clearance
between head of mow/transport sensor and the mow
speed limiter has not changed.
3. After adjustment to the mow/transport sensor, use
the Diagnostic Display (see Special Tools in this chap-
ter)to verifythat mow/transportsensorand circuitwiring
are functioning correctly (see Mow/Transport Sensor in
the Component Testing section of this chapter).
1. Mow/transport sensor 2. Mow speed limiter
Figure 12
1
2
Electrical
System