Filter
Top Products
Reelmaster 7000Hydraulic System Page 4 -- 92
Rear Axle and Front Wheel Motor Service
1. Drive shaft
2. Backplate
3. Housing assembly
4. Rotating assembly
5. Cam plate insert
6. Retaining ring
7. Cap screw
8. Shaft seal (front motor only)
9. Retaining ring
10. Thrust race
11. O--ring
12. Valve plate
13. Thrust bearing
14. Roll pin
15. Roll pin
16. Bearing
17. Bearing
18. Washer
19. Plug
20. O--ring
Figure 66
15 to 18 ft--lb
(20to24N--m)
7
2
11
14
3
17
15
16
12
4
5
19
20
6
1
9
10
13
9
10
8
18
FRONT WHEEL MOTOR SHOWN
NOTE: Thefrontwheelmotors(showninFigure66) are
identical.The rearaxle motoris similar tothefront wheel
motors.Service ofthe frontand rear motorsrequires the
same procedure.
NOTE: The rear axle motor does not have a shaft seal
(item 8). The case drain from the rear axle motor pro-
vides lubrication for the input gear case ofthe rear axle.
NOTE: For service of the wheel motors, see the Eaton
Model 74318and 74348 Piston Motors: FixedDisplace-
ment, Valve Plate Design Repair Information at the end
of this chapter.