Filter
Top Products
Reelmaster 7000 Page 7 -- 19 Chassis
Removal (Fig. 17)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Release hood latches and raise hood.
3. Removehair pins andwashers from pivotpins on ra-
diator frame.
4. Remove hood from pivot pins and machine.
5. If necessary, disassemble hood using Figure 17 as
a guide.
Installation (Fig. 17)
1. If components were removed from hood, assemble
hood using Figure 17 as a guide.
2. Slide hood frame onto radiator frame pivot pins.
3. Secure hood to frame with hair pins and washers.
4. Check hood alignment for correct operation of hood
latches and dust seals.
Chassis