Filter
Top Products
Reelmaster 7000 Page 7 -- 9 Chassis
Removal (Fig 7)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Removecutting unit assembly from liftarm (see Cut-
ting Unit Removal in the Service and Repairs section of
Chapter 8 -- DPA Cutting Units).
3. If lift arm for either cutting unit #4 or #5 ( Fig. 8) is to
beremoved, removehose guide(item27 or28) fromthe
cutting unit.
4. Remove one (1) retaining ring and washer from the
cylinder pin (item 4). Remove cylinder pin from the lift
arm and cylinder rod clevis which will free lift cylinder
from lift arm.
5. Loosen and remove lock nut (item 11) from lift arm
pivot pin.
6. Support lift arm and pull lift armpivot pin fromlift arm
and frame. Locate and remove thrust washer (item 10)
from rear of lift arm during pivot pin removal.
7. Disassemble lift arm as needed using Figure 7 as a
guide.
8. Clean lift arm and pivot pin. Inspect lift arm bushings
and pivotpin for damageor wear.Replace worn ordam-
aged components.
Installation (Fig 7)
1. Assemble lift arm using Figure 7 as a guide.
2. Position lift arm to frame. Fit thrust washer (item 10)
between rear of lift arm and frame. Slide pivot pin into
frame and lift arm. Align roll pin in pivot pin with slot in
frame flange.
3. Install and tighten lock nut (item 11) to secure lift arm
pivot pin.
4. Position lift cylinder rod clevis to lift arm
5. Make sure thatone (1) retaining ring and washer are
installed on cylinder pin (item 4). Insert cylinder pin
through the lift arm and lift cylinder clevis. Secure pin
with second washer and retaining ring. Make sure that
retaining ring is fully seated in pin.
NOTE: Install thrust washer (item 10) on carrier pivot
shaft before installing cutting unit on pivot shaft.
6. Positionand installcutting unitto liftarm (seeCutting
Unit Installation in the Service and Repairs section of
Chapter 8 -- DPA Cutting Units).
7. Iflift arm for eithercutting unit #4 or#5 was removed,
install hose guide (item 27 or 28) to the cutting unit.
8. Lubricate lift arm andlift cylindergrease fittings after
assembly is complete.
9. After assembly, raise and lower the cutting unit to
verify that hydraulic hoses and fittings do not contact
anything.
Figure 8
CUTTING
UNIT
LOCATIONS
#4 #1 #5
#2 #3
Chassis