Filter
Top Products
Reelmaster 7000 Page 5 -- 19 Electrical System
Indicator Lights
Charge Indicator Light
Thechargeindicatorlight shouldcomeonwhenthe igni-
tion switch is in ON with the engine not running or with
an improperly operating charging circuit while the en-
gine is running.
To test the charge indicator light and circuit wiring,
ground the white wire attached to alternator. Turn igni-
tionswitchtoON;thechargeindicatorlightshouldillumi-
nate indicating correct operation of the electrical wiring
to the alternator.
Engine Oil Pressure Light
The oil pressure light should come on when the ignition
switch is in the ON position with the engine not running.
Also, it should light with the engine running if the engine
oil pressure drops below 7 PSI (0.5 kg/cm
2
).
Totesttheoilpressurelightandcircuitwiring,groundthe
green wire attached to oil pressure switch located on
right side of engine near the starter motor. Turn ignition
switchtoON;the oilpressurelightshouldilluminateindi-
cating correct operation of the electrical wiring to the oil
pressure switch.
High Temperature Warning Light
If theengine coolanttemperature rises toapproximately
220
o
F (105
o
C), the high temperature light should come
on and the PTO (cutting units) will disengage.
To test the high temperature shutdown light and circuit
wiring, start the engine and ground the gray wire at-
tached to the temperature sender attached to water
flange on engine (see Temperature Sender in this sec-
tion). Warning light should illuminate.
Glow Plug Indicator Light
The glow plug light should come on when the ignition
switch is placed in ON/PREHEAT prior to placing the
ignition switch in START. The light should stay lit for
approximately seven (7) seconds while the ignition
switch is left in ON.
Testing Indicator Lights
1. Apply 12 VDC to terminals 1A and 2A.
2. Ground terminals 1B and 2B.
3. Both indicator lights should light.
1. Charge indicator
2. Engine oil pressure
3. High temp indicator
4. Glow plug indicator
Figure 19
4
1
2
3
Figure 20
1. Charge indicator
2. Engine oil pressure
3. High temp warning
4. Glow plug indicator
5. Warning light back
1A (+)
2A (+)2B
1B
4
1
5
3
2
Electrical
System