Filter
Top Products
Reelmaster 7000 Page 5 -- 45 Electrical System
Hydraulic Solenoid Valve Coils
A solenoid valvecoil on a hydraulic control manifoldcan
be replaced without opening the hydraulic system.
Removal (Fig. 61)
1. Park machine on a level surface, lower cutting units,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Locate solenoid valve coil that is to be removed.
3. Disconnect wire harness electrical connector from
the coil that is to be removed. Note orientationof electri-
cal connector on coil for assembly purposes.
4. Remove nut that secures coil to hydraulic valve.
5. Slide solenoid coil from valve.
6. Clean any corrosion or dirt from valve stem.
Installation (Fig. 61)
1. Slide solenoid coil onto the hydraulic valve. Position
coil so that connector is properly orientated.
2. Install nut onto valve and torque nut 60 in--lb (6.8
N--m) (do not over tighten).
3. Connect machine wire harness connector to the so-
lenoid coil.
1. Control manifold
2. Solenoid valve
3. Solenoid coil
4. Nut
Figure 61
2
4
3
60 in--lb
(6.8 N--m)
1
LIFT/LOWER CONTROL MANIFOLD SHOWN
Electrical
System