Filter
Top Products
Commands Listed in Alphabetical Order
BUS
Sets or returns the parameters for each bus. These parameters affect either the
Serial Trigger Setup or the Bus Display.
Conditions
This command requires a DPO4AUTO, DPO4EMBD, or DPO4COMP application
module.
Group
Bus
Syntax
BUS
BUS:B<1-4>:AUDio:BITDelay
Sets or returns the number of delay bits for the AUDIO bus.
NOTE. This command is applicable only for TDM audio bus type
(
BUS:B<x>AU Dio:TYPe TDM
)
Conditions
This command requires DPO4AUDIO application module.
Group
Bus
Syntax
BUS:B<1-4>:AUDio:BITDelay <NR1>
BUS:B<1-4>:AUDio:BITDelay?
Arguments
<NR1> specifies the number of delay bits.
Examples
BUS:B1:AUDIO:BITDELAY 2 sets the bit delay to 2.
BUS:B1:AUDIO:BITDELAY? might return :B US:B1:AUDIO:BIT DELAY 1
indicating that the number of delay bits is 1.
BUS:B<1-4>:AUDio:BITOrder
Sets or returns the bit order for the AUDIO bus.
Conditions
This command requires DPO4AUDIO application module.
MSO4000 and DPO4000 Series Programmer Manual 2-83