Filter
Top Products
Commands Listed in Alphabetical Order
BUS:B<x>:CAN
:PRObe
Sets or returns the probing method to probe CAN bus <x>, where x is the bus
number.
Conditions
This command requires a DPO4AUTO application module.
Group
Bus
Syntax
BUS:B<x>:CAN:PRObe {CANH|CANL|RX|TX|DIFFerential}
BUS:B<x>:CAN:PRObe?
Arguments
CANH specifies the single-ended CANH signal, as specified by the CAN standard.
CANL specifies the single-ended CANL signal, as specified by the CAN standard.
RX specifies the receive signal on the bus side of the CAN transceiver.
TX specifies the transmit signal.
DIFFerential specifies the differential C AN signal.
BUS:B<x>:CAN:SAMPLEpoint
Sets or returns the sampling point during each bit period for bus <x>, where x
is the bus number
Conditions
This command requires a DPO4AUTO application module.
Group
Bus
Syntax
BUS:B<x>:CAN:SAMPLEpoint <NR1>
BUS:B<x>:CAN:SAM
PLEpoint?
Arguments
<NR1> is the sample point in percent. Values are limited to 2 5, 30, ... 70, 7 5.
BUS:B<x>:CAN:SOUrce
Sets or returns the CAN bus data source for bus <x>, where x is the bus number.
Conditions
This command requires a DPO4AUTO application module.
2-92 MSO4000 and DPO4000 Series Programmer Manual