Filter
Top Products
Commands Listed in Alphabetical Order
<NR1> =0stopsa
cquisitions; any other value starts acquisitions.
Examples
ACQUIRE:STATE RUN starts the acquisition of waveform d ata and resets the count
of the number
of acquisitions.
ACQUIRE:STATE? might return:ACQUIRE:STATE 0 indicating that the
acquisition is stopped.
ACQuire:STOPAfter
Sets or returns whether the oscilloscope continually acquires acquisitions or
acquires a single sequence.
Group
Acquisition
Syntax
ACQuire:STOPAfter {RUNSTop|SEQuence}
ACQuire:STOPAfter?
Related Commands
ACQuire:STATE
Arguments
RUNSTop specifies that the oscilloscope will continually acquire data, if
ACQuire:STATE is turned on.
SEQuence specifies that the next acquisition will be a single-sequence acquisition.
Examples
ACQUIRE:STOPAFTER RUnsTOP sets the oscilloscope to continually acquire data.
ACQUIRE:STOPAFTER? might return:ACQUIRE:STOPAFTER SEQUENCE
indicating that the next acquisition the oscilloscope makes will be of the
single-sequence type.
ALIas
Sets or returns the state of alias functionality. Use Alias commands to define new
commands as a sequence of standard commands. You may find this useful when
repeatedly using the same commands to perform certain tasks like setting up
measurements. Aliases are similar to macros but do not include the capability to
substitute parameters into alias bodies.
To use Alias commands, first define the alias, then turn on the alias state.
Group
Alias
MSO4000 and DPO4000 Series Programmer Manual 2-73