Filter
Top Products
Commands Listed in Alphabetical Order
Group
Status and Erro
r
Syntax
*RST
Related Commands
FACtory, RECAll:SETUp, SAVe:SETUp, *PSC, *RCL , *SAV
Arguments
None
Examples
*RST resets the oscilloscope settings to factory defaults.
*SAV (No Query Form)
Stores the state of the o scilloscope to a specified memory location. You can use
the *RCL command to restore the oscilloscope to this saved
state at a later time.
Group
Save and Recall
Syntax
*SAV <N R1>
Related Commands
*RCL, RECAll:SETUp, SAVe:SETUp
Arguments
<NR1> specifies a location in which to save the state of the oscilloscope. Location
values range from 1 through 10. Using an out-of-range location value causes an
execution error. Any settings that have been stored previously at this location
will be overwritten.
Examples
*SAV 2 saves the current oscilloscope state in memory location 2.
SAVe:ASSIgn:TYPe
Sets or returns the assignment of the data to be saved when the front-panel Save
button is pressed.
Group
Save and Recall
Syntax
SAVe:ASSIgn:TYPe {IMAGe|WAVEform|SETUp}
SAVe:ASSIgn:TYPe?
MSO4000 and DPO4000 Series Programmer Manual 2-323