Filter
Top Products
Commands Listed in Alphabetical Order
TRIGGER:A:BUS
:B1:FLEXRAY:HEADER:PAYLENGTH ?
might return
TRIGGER:A:BUS:B1:FLEXRAY:H EADER:PAYLENGTH "XXXXXXX" indicating
the FLEXRAY header paylength is don’t care.
TRIGger:A:B
US:B<x>:I2C:ADDRess:MODe
Sets or returns the I
2
C address mode to 7 or 10-bit. Applies to bus <x>, where x
is the bus number.
Conditions
This command r equires a DPO4EMBD application module.
Group
Trigger
Syntax
TRIGge
r:A:BUS:B<x>:I2C:ADDRess:M ODe {ADDR7|ADDR10}
TRIGger:A:BUS:B<x>:I2C:ADD Ress:MODe?
Arguments
ADDR7 specifies the 7-bit I
2
C address mode.
ADDR10 specifies the 10-bit I
2
Caddressmode.
Examples
TRIGGER:A:BUS:B1:I2C:ADDRE SS:MODE ADDR10 sets the I2C address mode
to 10-bit.
TRIGger:A:BUS:B<x>:I2C:ADDRess:TYPe
Sets or returns the I
2
C address type. The only supported address type is USER.
Applies to bus <x>, where x is the bus number.
Conditions
This command r equires a DPO4EMBD application module.
Group
Trigger
Syntax
TRIGger:A:BUS:B<x>:I2C:ADD Ress:TYPe
{GENeralcall|STARtbyte|HSm ode|EEPROM|USER }
TRIGger:A:BUS:B<x>:I2C:ADD Ress:TYPe?
Arguments
GENeralcall specifies a general call address.
STARtbyte specifies a start byte address.
MSO4000 and DPO4000 Series Programmer Manual 2-413