Filter
Top Products
Commands Listed in Alphabetical Order
Syntax
TRIGger:A:LOG
Ic:INPut:CLOCk:EDGE {FALL|RISe}
TRIGger:A:LOGIc:INPut:CLOC k:EDGE?
Arguments
RISe specifies to trigger on the rising or positive edge of a signal.
FALL specifies to trigger on the falling or negative edge of a signal.
TRIGger:A:LOGIc:INPut:CLOCk:SOUrce
Sets or returns the channel to use as the clock source. The clock can be selected as
NONE. A selection of None implies pattern trigger. Any other selection implies
state trigger.
Group
Trigger
Syntax
TRIGger:A:LOGIc:INPut:CLOC k:SOUrce {CH1|CH2|CH3|CH4|
D0|D1|D2|D3|D4|D5|D6|D7|D8 |D9|D10|D11|D12 |D13|D14|D15|NONE}
TRIGger:A:LOGIc:INPut:CLOC k:SOUrce?
Arguments
CH1–CH4 specifies the analog input channel source.
D0–D15 specifies the digital input channel source.
NONE specifies a Pattern trigger.
TRIGger:A:LOGIc:INPut:D<x>
Sets or returns the logic pattern for a trigger on digital channel <x>, where x
is the channel number.
Group
Trigger
Syntax
TRIGger:A:LOGIc:INPut:D<x> {HIGH|LOW|X }
TRIGger:A:LOGIc:INPut:D<x> ?
Arguments
High specifies the logic high state.
Low specifies the logic low state.
X specifies a "don’t care" state.
MSO4000 and DPO4000 Series Programmer Manual 2-433