Filter
Top Products
Command Groups
Table 2-28: Power Commands (cont.)
Command Description
POWer:SOA:RESult:NUMACq? Returns the number of acquisitions in the test
POWer:SOA:RESult:STATe? Returns the pass/fail state of the SOA test
POWer:STATIstics Clears all the accumulated statistics of all
measurements
POWer:STATIstics:M OD E Enables or disables the display of the
measurement statistics
POWer:STATIstics:WEIghting Sets the number of samples which are
included for the statistics computations for
mean and the standard deviation
POWer:SWLoss:CONDCALCmethod Sets or returns the power application
switching loss conduction calculation m ethod
POWer:SWLoss:CONDuction:ENERGY:
MAX?
Returns the maximum conduction energy for
the switching loss calculation
POWer:SWLoss:CONDuction:ENERGY:
MEAN?
Returns the mean conduction energy for the
switching loss calculation
POWer:SWLoss:CONDuction:ENERGY:
MIN?
Returns the minimum conduction energy for
the switching loss calculation
POWer:SWLoss:CONDuction:POWER:
MAX?
Returns the maximum conduction power for
the switching loss calculation
POWer:SWLoss:CONDuction:POWER:
MEAN?
Returns the mean conduction power for the
switching loss calculation
POWer:SWLoss:CONDuction:POWER:
MIN?
Returns the minimum conduction power for
the switching loss calculation
POWer:SWLoss:DISplay Sets or returns the display selection for
switching loss results
POWer:SWLoss:GATe:POLarity Sets o r returns the switching loss gate
polarity
POWer:SWLoss:GATe:TURNON Sets or returns the gate turn on level for
switching loss power measurements
POWer:SWLoss:NUMCYCles? Returns the number of cycles counted for the
switching loss calculation
POWer:SWLoss:RDSon Sets or returns RDSON value for use
in switching loss calculations when the
conduction calculation method is RDSON
POWer:SWLoss:REFLevel:ABSolute:
GATEMid
Sets or returns the mid voltage reference
level used in switching loss power
measurements in volts
POWer:SWLoss:REFLevel:ABSolute:
LOWCurrent
Sets orreturns the low currentreference level
used in switching loss power measurements
in amperes
2-38 MSO4000 and DPO4000 Series Programmer Manual