Filter
Top Products
Commands Listed in Alphabetical Order
SEARCH:SEARCH
<x>:TRIGger:A{:TRANsition|:R ISEFall}:SOUrce?
Arguments
CH1–CH4 specifies one input channel as the edge source.
MATH specifies the math waveform as the search source.
SEARCH:SEARCH<x>:TRIGger:A{:TRANsition|:RISEFall}:WHEn
Sets or returns the condition setting for an transition trigger search to determine
where to place a mark. <x> is the search number.
Grou
p
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A {:TRANsition|:R ISEFall}:WHEn
{SLOWer|FASTer|EQual|UNEQu al}
SEARCH:SEARCH<x>:TRIGger:A {:TRANsition|:R ISEFall}:WHEn?
Arguments
FASTer sets the trigger to occur when the transitioning signal is faster than the set
volts/second rate.
SLOWer sets t
he trigger to occur when the transitioning signal is slower than
the set volts/second rate.
EQual sets the trigger to occur when the transitioning signal is equal to the set
volts/second rate within a ±5% tolerance.
UNEQual sets the trigger to occur when the transitioning signal is not equal to
the set volts/second rate ±5%.
SEARCH:SEARCH<x>:TRIGger:A:TYPe
Sets or returns the trigger type setting for a search to determine where to place a
mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger:A :TYPe
{EDGe|SETHold|PULSEWidth|R UNt|TRANsition| LOGIc|BUS (wi th the
appropriate application module installed)}
SEARCH:SEARCH<x>:TRIGger:A :TYPe?
Arguments
RUNt triggers when a pulse crosses the fi rst preset voltage threshold but does not
cross the second preset threshold before recrossing the first. The thresholds are
MSO4000 and DPO4000 Series Programmer Manual 2-381