Filter
Top Products
Commands Listed in Alphabetical Order
Related Commands
WFMOutpre:ENC
dg
Arguments
ASCii specifies that the incoming data is in ASCII format.
BINary specifies that the incoming data is in a binary format whose further
interpretation requires knowledge of BYT_NR, BIT_NR, BN_FMT, and
BYT_OR.
Examples
WFMINPRE:ENCDG ASC sets the format of incoming waveform data to ASCII
format.
WFMINPRE:ENCDG ? might return :WFMINPRE:ENCDG BIN indicating that the
incoming waveform data is in binary format.
WFMInpre:NR_Pt
Sets or returns the number of data points that are in the incoming waveform record.
Group
Waveform Transfer
Syntax
WFMInpre:NR_Pt <NR1>
WFMInpre:NR_Pt?
Related Commands
CURVe, DATa, DATa:STARt, DATa:STOP, SAVe:WAVEform,
SAVe:WAVEform:FILEFormat, WFMOutpre:NR_Pt?
Arguments
<NR1> is the number of data points if WFMInpre:PT_Fmt is set to Y. It is the
number of min-max pairs if WFMInpre:PT_Fmt is set to ENV.
Examples
WFMINPRE:NR_PT 10000 specifies that 10000 data points will be expected.
WFMINPRE:NR_PT ? might return :WFMIN PRE:NR_PT 10 000 indicating that
there are 10000 data points in the expected incoming waveform record.
WFMInpre:PT_Fmt
Sets or returns the point format of the incoming waveform data. Regardless of
the argument used, the scale, offset, and so on are interpreted similarly. When
ENV is used, waveform data is interpreted over the min-max pair; when Y is
used, it is interpreted over a single point.
MSO4000 and DPO4000 Series Programmer Manual 2-481